1/2
አዲስ አበባ, አራዳ, 18/05
25 እይታዎች
Ramps 1.4 Shield – 3d Printer Control Board
Other
ብራንድ
ሌላ
አይነት
አዲስ
ሁኔታ
Standard interfaces (as that of extruder)
Reserved GCI like I2C and RS232
MOSFET 3 MOSFET are applied to the heater/ fan and thermistor circuit.
Another 5A added to protect the component parts.
An 11A fuse is added to the hotbed
Support 5 stepper drive board
The adoption of Pin Header as pololu makes it more convenient to repair or change.
I2C and SPI are reserved for expanding
All the MOSFET can be controlled by PWM
Use the interface of servo motor to adjust the level of printing platform automatically.
Adding a SD module for SD ramps module.
LED can indicate the status of the heater (the open and close of MOS).
ETB 2,000
የተሰኘ ዋጋየደህንነት ምክሮች
- እንኳንም ለመላኪያ በቅድሚያ መክፈልን ይቀልዱ
- ከሻጭ ጋር በደህንነቱ የተጠበቀ የህዝብ ቦታ ውስጥ ይገናኙ
- እቃውን ይመልከቱ እና በትክክል የሚፈልጉት መሆኑን ያረጋግጡ
- ተሸክመው የተላኩት እቃ የተመረምረው መሆኑን ያረጋግጡ
- እርካታ ካልሰማምን ብቻ ይክፈሉ
